Raytheon Anschütz SYNAPSIS ECDIS, Operator'S Manual

Page: 245 / 434

Operator Manual
8--34
4343DOC020102 Edition: November 2019
NOTE
It might happen, that some turns (e.g. in canals or port entries) need a
smaller turning radius than the given default turning radius, in this case
the turning radius will be reduced adequately on the relevant turns and
an information is provided in the status area of the window.
In some cases it might be possible that the route can be created but it
will not be possible to edit the route afterwards. The reason is, that in
some port entries and narrow passages the waypoints are located too
densely to allow modifications.
If the system can not create a route between two locations, this may
have one of the following causes:
-- Either a port or a part of the route is too shallow for the given draft.
-- The route would contain a too sharp turn for a valid route.
-- All possible passages are disabled.
Possible solutions:
-- Select a manually entered start or end position outside the port.
-- Verify the given draft.
-- Enable Inshore Zones and rivers if possible
-- Enable required passages.
Step 2 Press the Calculate button, a route description is displayed in the
dialog window from the dialog box.
If there is already a secondary route, a confirmation request for
clearing the existing secondary route will be displayed. If the existing
secondary route has not been saved, you get the choice to save the
route now.