6.3.8.2 Using Profiles
When using Profiles you can select (name) what you want to measure on your test object. The
measurement results are then stored with the corresponding label in the right place.
This feature is very useful if utilizing a Raytech multiplexer which will automatically set the
appropriate relay. Thus, with a multiplexer, you connect the measurement cables to a Transformer
only once and all measurements are completed without changing any cables.
WS
: Select the Winding System (1 Primary, 2
Secondary or 3 Tertiary side of the
Transformer). The configuration of the
appropriate winding can be made.
Caption
: Select the point locations to be
measured.
7
Check the checkbox in the Setup under "General"
Instruction Manual Winding Resistance Meter
Type WR100 / WR50 / WR14
Page 58 of 139
