When remote control is chosen for a device a new
ribbon tab
is created and automatically
selected. Running processes like remote control or data exchange will not be affected. The newly
created
ribbon tab
may appear differently for several Raytech devices.
The
device control
section contains all options to set up a device and do measurements. With a
few clicks a measurement is started and the results are displayed in the
results section
immediately.
Details about the device status and communication are shown in the
status
section. In the screen
example below a winding resistance meter is connected. The meter status is safe and data
exchange is listed in the console.
A.6 USB Driver for T-Base Pro
The USB Drivers must be activated to allow communicaton between the Raytech instrument and a
computer. This is accomplished by entering a simple Service Code:
2001#
This is described further in chapter C.4 Raytech USB Driver for T-Base on page 121.
Instruction Manual Winding Resistance Meter
Type WR100 / WR50 / WR14
Page 116 of 139
