In the case of SSB radios, the distance should be increased
to 7 ft (2 m).
– More than 2 m (7 ft) from the path of a radar beam. A radar
beam can normally be assumed to spread 20 degrees above
and below the radiating element.
• The product is supplied from a separate battery from that used
for engine start. This is important to prevent erratic behavior
and data loss which can occur if the engine start does not have
a separate battery.
• Cables are not cut or extended, unless doing so is detailed in
the installation manual.
Note: Where constraints on the installation prevent any of
the above recommendations, always ensure the maximum
possible separation between different items of electrical
equipment, to provide the best conditions for EMC performance
throughout the installation
Product
disposal
Dispose
of
this
product
in
accordance
with
the
WEEE
Directive.
The Waste Electrical and Electronic Equipment (WEEE)
Directive requires the recycling of waste electrical and electronic
equipment. Whilst the WEEE Directive does not apply to some
Raymarine products, we support its policy and ask you to be aware
ofhow to dispose of this product.
Warranty registration
To register your STV Satellite television system ownership, please
the box, or visit
www.raymarine.com
and register on-line.
It is important that you register your product to receive full warranty
serial number of the unit. You should stick this label to the warranty
registration card.
Technical accuracy
To the best of our knowledge, the information in this document was
correct at the time it was produced. However, Raymarine cannot
accept liability for any inaccuracies or omissions it may contain. In
addition, our policy of continuous product improvement may change
liability for any differences between the product and this document.
Suppression
ferrites
Raymarine
cables
may
be
tted
with
suppression
f errites.
These
are
important
for
correct
EMC
performance.
If
a
ferrite
has
to
be
removed
for
any
purpose
(e.g.
installation
or maintenance),
it
must
be
replaced
in
the
original
position
before
the
product
is
used.
Use only ferrites of the correct type, supplied by Raymarine
authorized dealers.
Connections to other equipment
Requirement for ferrites on non-Raymarine cables
If your Raymarine equipment is to be connected to other equipment
using a cable not supplied by Raymarine, a suppression ferrite
MUST always be attached to the cable near the Raymarine unit.
• Raymarine specified cables are used.
take a few minutes to fill out the warranty registration card found in
benefits. Your unit package includes a bar code label indicating the
specifications without notice. As a result, Raymarine cannot accept
Summary of Contents for STV60
Page 80: ...80 Raymarine Satellite TV Antenna Systems ...
Page 81: ...Owner notes ...
