Raymarine RAY50, Installation And Operation Instructions Manual

Page: 38 / 116

5.1 Bracket mounting
Follow the steps below to mount the product on it’s
bracket.
Before mounting the unit ensure that you have:
• Selected a suitable location, ensuring there is
nothing behind the mounting surface that may be
damaged when drilling.
• Identified the cable connections and route that the
cables will take.
• Attached the front bezel.
D13204-1
1. Mark the location of the bracket mounting holes
on the mounting surface.
2. Drill holes for the mounting fixings using a drill
with a suitable sized drill bit.
3. Use the fixings provided to attach the bracket
securely to the mounting surface.
4. Attach the unit to the bracket and secure in place
using the bracket mounting knobs.
Note: Drill bit, tap size and tightening torque is
dependent on the thickness and type of material
the unit is to be mounted on.
5.2 Ray50 Panel mounting
Removing the mounting hole covers —
Ray50
Before the Ray50 can be panel mounted the
mounting hole covers must be removed.
D13205-1
1. Using a flat blade screw driver, insert the tip of
the screw driver in the slot between the back of
the cover and the unit.
2. Carefully lever the cover forward away from the
unit.
3. Repeat steps 2 and 3 for the remaining mounting
hole covers.
Drilling out the mounting holes – Ray50
The mounting holes must be drilled out.
Guides for the mounting holes can be found on the
corners of the unit, under the mounting hole covers.
x 4
D13206-1
1. Using a drill and a 4 mm (5/32) drill bit, drill out
the 4 mounting holes.
Holes should be drilled from the front of the unit,
taking care not to damage the unit by applying
too much force to the drill.
Panel mounting the Ray50
To panel mount the Ray50 follow the steps below.
Before mounting the product, ensure that you have:
• Selected a suitable location, ensuring there is
nothing behind the mounting surface that may be
damaged when drilling / cutting.
• Identified the cable connections and route that the
cables will take.
• Removed the mounting hole covers.
• Drilled out the mounting holes on the unit.
38
Ray50 / Ray60 / Ray70