Raymarine RAY50, Installation And Operation Instructions Manual

Page: 55 / 116

6.18 GPS/GNSS setup
If your radio includes an internal GPS/GNSS receiver
or if your radio is connected to a GPS/GNSS receiver
over
NMEA 0183 or SeaTalk ng® , the radio can
display relevant GPS information.
The following information can be displayed:
• latitude
• longitude
• UTC time
• COG and SOG
When GPS/GNSS data is available the satellite icon
is displayed onscreen.
If no GPS/GNSS data is available then the latitude,
longitude and time can be entered manually so that
it can be included in DSC distress transmissions.
Position data received from other vessels can be
displayed on a connected
Raymarine ® multifunction
display.
Enabling and disabling the internal GPS -
Ray70
From the GPS set-up menu: Menu > Set-up > GPS
set-up
1. Select Internal GPS .
Selecting Internal GPS will switch the internal
GPS/GNSS receiver On and Off.
No GPS position data
If no GPS data is available or GPS data becomes
unavailable; after 10 minutes an audible warning is
sounded, the GPS icon flashes and the
No position
data message is displayed.
Once the warning has been acknowledged the GPS
icon will continue to flash. The
No position data
warning is repeated every 4 hours if position data is
still unavailable, has not been entered manually or
has been entered manually but over 23.5 hours ago.
If position data has been entered manually the
display alternates between displaying the manual
position and time and the
Manual Position
message. if the manually entered position has not
been updated in the last 4 hours the GPS icon
flashes and an audible warning is sounded. This
warning will be repeated every 4 hours until position
is manually updated or GPS position data becomes
available.
Where no position data is available or has not been
manually updated for 23.5 hours then position data
will change to ‘9’s and time will change to ‘8’s.
Entering position manually
If GPS position data is not available it can be entered
manually.
From the GPS set-up menu: Menu > Set-up > GPS
set-up .
1. Select Set manual position .
The Manual position screen requires you to input
latitude, longitude and UTC time.
2. Use the Rotary knob to cycle through the
available numbers and press OK to confirm each
number and move to the next digit.
3. When the relevant information has been entered
select OK to confirm the details.
Selecting GPS information to display
You can change the GPS data that is displayed on
the Homescreen.
From the GPS set-up menu: Menu > Set-up > GPS
set-up .
1. Select Homescreen display .
2. Select the required option:
• Location & time
• Location & COG/SOG
The Homescreen display option is also available
from the Display set-up menu
Setting time format and offset
You can change the Format and Offset that is applied
to the time displayed onscreen.
From the Units menu: Menu > Set-up > Units .
1. Select Time format .
2. Select the desired format:
• 12 hour
• 24 Hour (default)
3. Select Time offset .
4. Adjust the offset to the desired value using the
Rotary knob or the Channel Up and Channel
Down buttons.
5. Select OK to confirm the selection.
Getting started
55