Raymarine i50 Depth, Installation And Operation Instructions Manual

Page: 53 / 90

7.10 Using the log, trip and
temperature pages
To cycle through the available log, trip and water
temperature pages follow the steps below.
1 0
15
20
25
30
35
40
45
50
55
60 5
3
D12534-2
T rip
T rip
T rip
T rip
R e s e t
1
2
3 4
1. Current Speed page
2. Log page
3. Trip page
4. Water temperature page
During normal operation:
1. Use the
Trip button to cycle through the available
pages.
2. From the Trip page, press and hold the Reset
button for approximately 3 seconds to reset the
reading.
7.11 Using the timers
To cycle through and use the Race Timer pages and
Stop Watch page follow the steps below.
D12535-2
T ime r T ime r
T ime r
During normal operation:
1. Press the
Timer button to cycle through the
available timers.
2. Press the Reset button to start the timer.
3. With the timer running, press the Reset button
to pause the timer.
4. With the timer running, press and hold the Reset
button for 1 second to reset the timer.
Note: After the race timers have counted down
to zero they will then start to count upwards from
zero.
Setting the race start timer
The race start timers can be set from 1 to 15 minutes.
+
-
D12536-2
+
+
1 2
T ime r
T ime r
R e s e t
R e s e t
T ime r R e s e t
With a race timer displayed
1. Press the Timer and Reset buttons at the same
time to adjust the race timer.
The set time will flash.
2. To change the race timer:
i. Use the Reset button to increase the race
timer start value, or
ii. Use the Timer button to decrease the race
timer start value.
iii. Press the Timer and Reset buttons at the
same time to confirm the new value.
Timer buzzer
The Timer buzzer is enabled or disabled during
calibration see the
User calibration section.
When using a race timer with the timer buzzer
enabled, the buzzer will:
• Short double beep every minute.
• 3 Long beeps at the start of the last 30 seconds.
• Short beep once for each of the last 10 seconds.
• Long beep at zero.
i50 Speed
53