1. Press the
Depth
button until the Speed Source
page is displayed (1 press from the
User
Calibration Access Menu
page).
D12483-2
D
e pth
2. Use the
Trip
or
Reset
buttons to switch the speed
data source On and Off (default).
Selecting On will display SOG reading instead of
speed transducer readings.
Setting the response delay for speed
readings
From the
User Calibration Menu Access
page:
1. Press the
Depth
button until the
Speed
Response
page is displayed (1 press from User
Calibration Menu Access
page).
D12484-2
D
e pth
2. Use the
Trip
and
Reset
buttons to adjust the
speed response to the required level.
The default level is 12. The levels available are 1
to 15 with level 1 being the slowest update rate
and level 15 the quickest.
Note:
To exit the Dealer Calibration pages at any
time, press and hold the
Depth
and
Speed
buttons
at the same time for approximately 2 seconds.
Setting the response delay for depth
readings
From the
User Calibration Menu Access
page:
1. Press the
Depth
button until the
Depth
Response
page is displayed (3 presses from the
User Calibration Menu Access
page).
D12485-3
D
e pth
2. Use the
Trip
and
Reset
buttons to adjust the
depth response to the required level.
The default level is 12. The levels available are 1
to 15 with level 1 being the slowest update rate
and level 15 the quickest.
Note:
To exit the Dealer Calibration pages at any
time, press and hold the
Depth
and
Speed
buttons
at the same time for approximately 2 seconds.
Enabling and disabling Boat Show Mode
From the User
Calibration Menu Access
page:
1. Press the
Depth
button until the
Boat Show
Mode
page is displayed (4 presses from
User
Calibration Menu Access
page).
D12486-2
D
e pth
2. Use the
Trip
or
Reset
buttons to switch boat
show mode On and Off (default).
Selecting On will put the display into boat show
mode.
Note:
Boat show mode is only suitable for
demonstration purposes and should NOT be used
whilst your vessel is in use.
Note:
To exit the Dealer Calibration pages at any
time, press and hold the
Depth
and
Speed
buttons
at the same time for approximately 2 seconds.
Resetting the display to factory defaults
From the User
Calibration Menu Access
page:
1. Press the
Depth
button until the
Factory
Defaults
page is displayed (5 presses from
User
Calibration Menu Access
page).
D12487-2
D
e pth
2. To reset the display to factory default settings:
i.
Use the
Trip
or
Reset
buttons to change the
reset option to Yes.
ii. Press the
Depth
button to reset your display
to factory default settings.
3. After a reset it is recommended that you check
the data master status of the display to ensure
it is set correctly. Refer to
for
details.
Note:
To exit the Dealer Calibration pages at any
time, press and hold the
Depth
and
Speed
buttons
at the same time for approximately 2 seconds.
64
i50
Summary of Contents for i50 Depth
