Raymarine i50 Depth, Installation And Operation Instructions Manual

Page: 37 / 90

Before attempting to set a waterline or keel
offset, find out the vertical separation between the
transducer and either the waterline or the bottom of
the keel on your vessel, as appropriate. Then set the
appropriate depth offset value.
D9343--2
1 2 3
1
Waterline offset
2
Transducer / Zero offset
3 Keel offset
If an offset is not applied, displayed depth readings
represent the distance from the transducer to the
sea bed.
Applying a Depth Offset
From the User Calibration Menu :
1. Press the Depth button until the Depth Offset
page is displayed (2 presses from User
Calibration entry page).
D12423-2
D e pth
2. Use the Offset and Reset buttons to select the
required depth offset value.
The depth offset can be set to the following
values:
•
Keel
— values between –9.9 to –0.1
•
OFFSET (default)
(Zero Offset) — 0.0
•
W/L
(Waterline) — values between 0.1 to 9.9
Note: To exit the user calibration pages at any
time, press and hold the Depth and Alarm buttons
at the same time for approximately 2 seconds.
6.7 Intermediate calibration — i50
Depth
Intermediate calibration allows you to:
• Check the instrument software version.
• Check and if necessary set the instrument status
as either Master or Repeater.
Checking i50 Depth software version and
status
1 0
15
20
25
30
35
40
45
50
55
60 5
4 +
D12451-2
D e pth A la rm
D e pth
During normal operation:
1. Press and hold the
Depth and Alarm buttons at
the same time for approximately 4 seconds, until
the Software Version page is displayed.
2. Press the Depth button to display the Instrument
Status page.
Master (transducer connected) or Repeater (No
transducer connected).
3. To change the status:
i. Press the Offset and Reset buttons at the
same time.
The status will flash.
ii. Press either the Offset or Reset to change
the status between Master or Repeater.
i. Press the Offset and Reset buttons at the
same time to confirm the status.
4. To exit the Intermediate calibration settings at
any time, press and hold the Depth and Alarm
buttons at the same time for approximately 4
seconds to return to normal operation.
i50 Depth
37