Raymarine i50 Depth, Installation And Operation Instructions Manual

Page: 67 / 90

8.13 Alarms
Alarms alert you to a situation or hazard requiring
your attention.
You can set up alarms to alert you to certain
conditions.
Alarms are raised by system functions, and also
external equipment connected to your display.
When an alarm event occurs an audible and visual
alarm is activated which indicates the alarm state.
Alarm thresholds can be configured from the relevant
alarm page / menu.
Instrument alarms
The alarms available for the i50 Depth and i50
Tridata are listed below.
• Shallow depth alarm
• Deep depth alarm
• Shallow anchor alarm
• Deep anchor alarm
Alarm indications
An alarm event is indicated by both audible and
visual warnings.
Shallow alarm
D13154-1
Deep alarm
D13155-1
Shallow anchor alarm
D13156-1
Deep anchor alarm
D13157-1
Alarms are sounded when the set alarm threshold
value is crossed. Alarms will sound until silenced.
Silencing alarms
1. Press any button to silence an active alarm.
Enabling / Disabling alarms
Alarms can be enabled or disabled at any time.
With the relevant alarm page displayed:
1. Press and hold the Reset button for 1 second to
switch the alarm on or off.
Setting alarm thresholds
You can adjust the threshold at which alarms are
triggered by following the steps below.
D12547-2
+
-
+
T rip
T rip
R e s e t
R e s e t
With the relevant alarm page displayed:
1. Press the
Trip and Reset buttons at the same
time.
The current alarm threshold will start to flash.
2. Use the Reset button to increase the alarm
threshold.
3. Use the Trip button to decrease the alarm
threshold.
4. The alarm threshold page will time-out
after approximately 6 seconds of inactivity,
automatically saving the new alarm threshold.
i50 Tridata 67