Wuhan Raycus Fiber Laser Technologies Co., Ltd.
User Guide of RFL-C4000XZ~12000XZ
40
Operations Steps:
a)
Turn the knob switch on the rear panel to“ON”
b)
Turn the key switch to“REM”
c)
Short-circuit pin 8/9 on XP2
d)
XP1-A1 connects to 24V
e)
Connect XP1-A5 to 24V and turn on the guide laser; after checking the optics, connect
XP1-A5 to 0V and turn off the guide laser
f)
XP1-C1 is connected to 24V, and the main power is turned on (users can also directly press
the “LASER” button, or the host computer software clicks the main power “ON”)
g)
Waiting for “Ready”
h)
XP1-(A8-14) select the number of the pre-executed program, set XP1-A2 high to start
executing the program.
Figure 28 Timing diagram
7 RS232 and INTERNET communication command
7.1 Port Configuration
RS-232 configuration is as follows:
baud rate :9600, data bit :8, stop bit :1, no parity bit and no control flow.
Ethernet port is configured as follows:
Default laser IP address :192.168.0.10
Laser port :10001
