Rayco RG25HD, Operator, Service, Maintenance, Parts Manual

Page: 38 / 72

RG25DH Operation • Service • Maintenance • Parts Manual
38
Maintenance
Storing the Machine
Preparing the Machine for Storage
Store the machine in a dry protected place. If the machine
must be stored outside, cover it with a waterproof canvas
or other material.
Clean all grease, dirt, mud and other foreign matter from the
machine. Wash the machine. Start and operate the machine
to help rid it of puddled or excess water. To inhibit rusting,
paint all exposed surfaces.
Remove the drive belts, and store them in wrapped condition.
Spray the grooves of the belt sheaves with an anti-corrosive
agent.
Store the battery inside where temperatures do not drop
below 32° F. Place the battery on wood, not on concrete floor
or steel table. Always keep the battery fully charged. Store
it away from wherever an open flame or sparks might occur.
Information on preparing the engine for storage, are contained
in the “Storage” section of the Kohler Engine Operation
Manual, shipped with this machine.
Check your machine for any worn or broken parts at this
time. By ordering and installing replacement parts now,
you can avoid unnecessary delays when you remove the
machine from storage.
Removing the Machine from Storage
Remove all coverings.
After prolonged storage, inspect the wheels and brakes.
Check the tires for proper inflation.
Check the fuel lines for deterioration, and replace as
necessary. Tighten all nuts, bolts, and replace the fuel filter.
Information on removing the engine from storage is contained
in the “Storage” section of the Kohler Engine Operation
Manual, shipped with this machine.
Wipe off the anti-corrosive agent from the grooves of the
belt sheaves and remount the belts.
Adjust the tension of the belts in accordance with the
instructions contained in this manual’s “Every 50 Service
Hours” section.
Mount the battery and connect the cables to the machine.
Review the machine according to the “Before Starting the
Engine” as found in the “Safety” section, and perform all
maintenance services necessary as described in the “10
Service Hours or Daily” interval of the “Maintenance” section
before starting the engine.
NOTICE
Do not start or run the engine with the “by-pass”
lever pushed in, or in “free-wheeling” position.
Damage will occur to the hydrostat. Use the “in”
position ONLY when you wish to move the unit
manually.
NOTICE
The electormagnetic clutch is maintenance free,
and burnished from the factory. If the clutch is
replaced, the clutch mating surfaces should be
burnished by the following procedure.