Rayco RG25HD, Operator, Service, Maintenance, Parts Manual

Page: 25 / 72

RG25DH Operation • Service • Maintenance • Parts Manual
800.392.2686
25
Pre-Operation Warm-Up
1. Allow the engine to warm up at low idle for two minutes.
2. Move the engine throttle to the maximum engine speed.
Run the engine for an additional two minutes.
This will allow the oil to reach relief pressure, which causes
it to warm up more rapidly.
Cutting Wheel Precautions
• NEVER go near the cutting wheel when the machine is
turned on. Turn off the machine first.
• Always cut with the machine downhill, below the stump.
• Use extreme caution on slopes. Slopes, combined with
less than ideal traction (ice, snow, gravel, leaves, wet
grass) can allow the machine to move unexpectedly.
Call 8-1-1 Before You Dig
One free, easy call gets your utility lines marked AND helps
protect your from injury and expense.
SAFE DIGGING IS NOT ACCIDENT!
ALWAYS CALL 811 BEFORE YOU DIG.
Know what’s below. Always call 811 before you dig.
Visit call811.com for more information.
Operation
A ROTATING CUTTING WHEEL IS VERY
DANGEROUS! STAND AT THE CONTROLS AND
ENSURE THE CUTTING WHEEL HAS COME TO A
COMPLETE STOP BEFORE WALKING AWAY FROM
MACHINE, OR DOING ANY OTHER WORK ON
MACHINE.
One free, easy call gets your utility lines
marked AND helps protect you from
injury and expense.
Safe Digging Is No Accident:
Always Call 811 Before You Dig
Know what’s below. Always call 811 before you dig.
Visit call811.com for more information.
CALL
DIG
BEFORE YOU
ALWAYS
INSERT
CALL CENTER
LOGO HERE
ONLY A PORTION OF THE CUTTING WHEEL WITH
THE 80° AREA SHOWN IN THE FOLLOWING IMAGE
SHOULD ENGAGE THE STUMP. NEVER UNDERCUT
THE STUMP OR USE THE BOTTOM OF THE
CUTTING WHEEL FOR CUTTING PURPOSES.
THE STUMP CUTTER’S CUTTING WHEEL IS
EXTREMELY POWERFUL. CONTACT WITH THE
CUTTING WHEEL WILL RESULT IN SERIOUS
INJURY OR DEATH.
DUE TO HIGH SPEED LOW-FRICTION ROTATION,
THE CUTTING WHEEL MAY CONTINUE TO ROTATE,
EVEN AFTER THE ON/OFF LEVER HAS BEEN
FLIPPED TO THE OFF POSITION. EVEN AFTER THE
ENGINE HAS STOPPED. BE SURE THE CUTTING
WHEEL ROTATION COMES TO A COMPLETE STOP
BEFORE MOVING THE MACHINE OR LEAVING THE
CONTROLS!