SECTION 1
INTRODUCTION
1.1
The Ravenheat boiler is for the use of
central and domestic hot water combined in
one unit.
It is fitted with an automatic domestic hot
water priority valve.
A ( w i n t e r / s u m m e r ) s e l e c t o r
switch is fitted to the left hand side of control
panel. With the only (summer) position
being for domestic hot water.
position being for central heating
with domestic hot water priority. The boiler
is equipped with a front cover which can be
removed for servicing. The data badge with
technical data is placed on the lower left
hand side of the frame.
1.2
Fig. 1 Illustrates the general layout of
components.
Fig. 2 Illustrates the operating principles
described in section 2.
SECTlON 2
2.1
DESCRIPTION OF CONTROL SYSTEM
AND SEQUENCE OF OPERATION
2.2
Domestic hot water mode
When the appliance is in rest mode with the
mains neon switch on. Switch the sum-
mer/winter switch in the position, mak-
ing sure the heating circuit is charged with
water (above 1 bar). When the domestic hot
water tap is turned on, the boiler will function
in the following sequence:
2.2.1
The pump starts.
The control board sensors.
The fan operates via the pressure switch
and sends a signal back to the ignition board
that the fan is running at maximum speed.
2.2.2
The spark ignition system is powered which
in turn commences the spark igniter to
operate and light the burner.
At this point the ignition board opens the first
step of the gas valve to light the pilot/burner.
2.2.3
When the electrode/sensor senses the
signal from the pilot/burner, it opens the
second stage of the gas valve via the ignition
board on minimum power. Upon the second
valve opening the spark igniter stops.
2.2.4
From the minimum gas rate setting the
boiler
i n c r e a s e s t o
the
maximum
permissible pressure over a period of 3 to 4
seconds and will remain at its maximum
required power until its maximum regulated
temperature.
2.2.5
When the domestic hot water tap is closed
the diverter valve goes back into rest mode,
the main burner is shut down along with the
pilot/burner. The pump and fan are also
2.2.6
2.2.7
2.3
2.3.1
2.3.2
2.3.3
2.3.4
2.3.5
2.3.6
2.3.7
switched off, the pressure switch returning
to its rest mode.
Central heating mode
If the switch is positioned on
with a
demand for heat to supply radiators, etc.
With heating circuit fully charged so as to
operate the low water sensor device the
boiler will start in the same way as domestic
hot water mode but with slightly differing
time delay in that it will start on minimum
and remain at this level for about 1 minute,
after which the flame will lift to its maximum
setting as governed by a potentiometer
range rates the heating circuit between
maximum and minimum power.
On the control panel are mounted two
potentiometers (thermostats) these control
the temperature. One is for domestic hot
water and the other for heating.
The boiler is fitted with an anti-cycling
device on the control board. This delays the
boiler from re-firing over a 2.5 minute period
when in heating mode. The domestic hot
water will always take priority and is
unaffected by the anti-cycling device.
GENERAL FUNCTION
Central Heating Mode
A potentiometer is installed on the electric
circuit board this permits regulation of the
boiler to partial heating requirements,
between the factory setting.
Air is drawn by the fan for combustion.
The fan also forces exhaust gas through the
flue to the outside, this creates a lesser
pressure in the sealed combustion chamber,
thus sucking in combustion air, through the
inlet duct.
The boiler water temperature is automatical-
ly controlled by a built in thermostat. .
Interior space temperature is set by the
room thermostat to be installed in the heat-
ing system. The boiler already carries con-
nection terminals for this thermostat, as well
as for a timeclock. The burner will continue
to operate until it is stopped by the timer or
one of the thermostats.
When the internal C.H. temperature sensor
intervene the main burner shuts down. The
fan stops but the pump continues to operate.
When the room thermostats intervene the
main burner shuts down. The fan stops and
the pump turns off.
6
Summary of Contents for RSF 82E
