5.4
5.4.1
5.4.2
5.4.3
5.4.4
5.4.5
5.4.6
5.5
5.5.1
POSITIONING OF THE BOILER
Fig. 22
- Remove the 2 screws that
secure the
upper part of the front panel of the cas-
ing (Fig. 19).
- Carefully slide the front panel a few mil-
limetres up towards the top of the appli-
ance until it is free from its slot, and then
lift off (Fig. 20).
Unscrew the 2 screws that fasten the lower
grating on the casing and remove it from
the sides of the casing (Fig. 22).
Fig. 23
Push down the 2 plastic clips that fasten the
instrument panel (Fig. 23).
Lower the instrument panel down by rotat-
ing it on its own hinges (Fig. 25).
Unscrew the 2 screws that fasten the two
side panels (Fig. 21).
Remove the two sides of the casing by slight-
ly lifting them and carefully sliding towards the
top of the appliance, to release them from
their upper suspension hooks (Fig. 26-27).
Fig. 25
Make sure the casing and screws are put to
one side in a safe place.
INSTALLING THE APPLIANCE FOR
REAR FLUE OUTLET
Use adhesive tape to attach the template to
the wall, making sure that the centre line is
vertical.
- Mark the four boiler fastening holes on the
wall as well as the centre of the flue duct.
- Detach the template from the wall.
- Use a 10 mm. dia drill to make the 4 boil-
er securing holes. Insert the plastic
expansion plugs.
- Cut or core drill a 105 mm. dia hole for
inserting the flue duct.
- Screw in the two upper coach bolts leaving
them about 10 mm. out from the wall to
enable the boiler to be located on the wall.
Fig. 27
Fig. 21
Fig. 28-29
Summary of Contents for RSF 82E
