4
Installation: Sidekick Pro™ ICD Injection System Plumbing
27
INSTALLATION
PLUMBING THE RINSE ASSIST 3-WAY VALVE TO THE INJECTION PUMP
The illustration below is a basic illustration of how to plumb the rinse assist valve to the pump. If needed,
additional plumbing can be added to allow for a better fit.
IMPORTANT:
The chemical tank must always be plumbed to the normally open port of the rinse valve. The rinse valve
comes set up with the ports as shown.
With power removed from the valve, the normally open port can be determined by looking into the left or right
portion of the valve. The side of the valve that shows the open side of the ball is considered the normally open
port.
IMPORTANT:
The check valve and the strainer must connect to the clean water rinse tank. The arrow on the check valve
must point towards the rinse valve.
FIGURE 11. Rinse Assist 3-Way Valve Plumbing
NOTE:
Install the 100 flanged fitting (item 10) between the pump and M100 flange gasket (item 6) when
clearance is needed for the flow monitor sensor.
