18
c
? ?
?
Lift to be used
by trained operator
only.
CAUTION
SAFETY
INSTRUCTIONS
c
Read operating
and safety manuals
before using lift.
c
Authorized personnel
only in lift area.
CAUTION
c
WARNING
Remain clear of lift
when raising or
lowering vehicle.
c
CAUTION
Use vehicle
manufacturer’s
lift points.
c
WARNING
Clear area if vehicle
is in danger of falling.
c
CAUTION
Auxiliary adapters
may reduce
load capacity.
c
CAUTION
Use height extenders
when necessary
to ensure
good contact.
OPERATING INSTRUCTIONS
WARNING: To avoid personal injury and/or property damage, permit only trained personnel to
operate lift. After reviewing these instructions, get familiar with lift controls by running the lift
through a few cycles before loading vehicle on lift.
IMPORTANT: Always lift the vehicle using all four adapters. NEVER raise just one end, one corner,
or one side of vehicle.
1. Before Loading: Lift must be fully lowered and
service bay clear of all personnel before the
vehicle is brought on lift. Swing arms out to full
drive-thru position.
2.
Spot vehicle over lift. Make sure you are using
the correct adapter, Fig. 1.
3. Loading: Swing arms under vehicle and
position adapters at vehicle manufacturer’s
recommended lift points, Fig. 2.
Use intermediate, high step, or optional
adapters for under body clearance when
required.
Note: Allow (2) seconds between motor starts.
Failure to comply may cause motor burnout.
DO NOT rest adapter against edge of arm.
4. To Raise Lift:
A.For all lifts. Push Raise switch on power unit,
Fig. 3.
B. Stop before making contact with vehicle. Check
arm restraint pins for engagement. If required,
slightly move arm to allow restraint gear and
pawl to mesh. DO NOT hammer pin down as
this will damage the restraint gear teeth.
C. Raise vehicle until tires clear the floor.
D. Stop and check adapters for secure contact
at vehicle manufacturer’s recommended lift
points.
E. Continue to raise to desired height only if
vehicle is secure on lift.
F. Do Not go under vehicle if all four adapters are
not in secure contact at vehicle manufacturer’s
recommended lift points.
G. Repeat complete spotting, loading and raising
procedures if required.
H. Lower lift onto locking latches.
0496-M004-0
