INSTRUCTION, USE AND
MAINTENANCE MANUAL
EN
Page 69 of 91
14.9 Special balancing programs
14.9.1 Pax
PAX mode is a special procedure specially devised to
balance wheels using the “PAX System ®”. 2 adhesive
weights on different planes are used on rim inner side.
To launch a PAX measurement, proceed as follows:
- Make sure there are no stones and/or mud on the
wheel. Remove any counterweights. Fit the wheel and
make sure it is properly fastened (see Chap. 12).
- Press
button from “Home” page. On the screen
that appears, press the button
to switch to
measuring mode selection screen below.
Use the arrows
or
to select PAX mode.
At the end press push button
. The machine
will be configured as follows to perform the meas-
urement and on the video screen will appear the
indication of the specific measures of the selected
wheel type.
- Close the protection guard to perform the automatic
wheel spin.
In just a few seconds, the wheel runs at normal speed
and the monitor shows wheel rotation.
After the spin, the wheel stops automatically, taking
into account the measured unbalance so that the fitting
position of the weight will be at “12 o'clock”.
The monitor show the weight required to correct the
unbalance.
Open the protection guard and proceed to fit the
adhesive weight as shown for the ALU-S mode (see
Par. 14.7.5).
14.10 Recalculation function
After making a spin, the wheel automatically stops,
indicating the weight/s to be fitted and its/their position.
In case the operator does not want the type of wheel
balance proposed by the machine (program type,
weights size, etc ...), proceed with the re-calculation
of the wheel balancing without rerunning the spin of
the wheel.
To do this, proceed as described below:
- press the button
to return to the measures
detection/program selection page;
- select a new balancing program as indicated in Par.
14.2.2;
- take with the gauge arm the measures required by
the selected program;
- press button
to perform the re-calculation.
The monitor will display the weights and the posi-
tions in which they will be applied.
If also in this case the operator should decide to fur-
ther modify the balancing program, it is sufficient to
proceed as described above without having to spin
the wheel.
When the result of the recalculation does not satisfy
the operator, it is recommended to do a spin of the
wheel to confirm the findings from the operation of
recalculation itself.
After the launch of the wheel, the machine, in addi-
tion to displaying the unbalance value, draw up au-
tomatically all the programs measurement fields that
are consistent with those measures that were taken
previously and at the same time erases all measures
which are not consistent.
1297-M058-00
G3.150 - GP3.150 - G3.150S - GP3.150S - G3.150WS - GP3.150WS - G3.150WSPLUS - GP3.150WSPLUS - G3.150SA - G3.150WSA
RAVAGLIOLI S.p.A.
