Rauch QUANTRON-A AXIS-M 20 Q, Instruction Manual

Page: 107 / 116

Alarm messages and possible causes
101
6
34 The spreader ist set to re-
duced disc speed. The idle
measurement cannot be
started; Confirm this alarm to
set the machine back to nor-
mal spreading mode. The flow factor must lie within a range of
0.50 - 1.80 .

The newly calculated or entered flow
factor is outside the range.
36 Weighing quantity impossi-
ble. Machine must stop. Alarm message during weighing.

The Weigh quantity function can only
be carried out if the machine is at a
standstill and in a horizontal position.
45 Error M-EMC sensors. EMC
control deactivated! The sensor does not send any signals

Cable breakage

Defective sensor
46 Spreading speed error. Ob-
serve spreading speed of
450..650 rpm! The PTO speed is outside the range for the
M EMC function.
47 Left dosing error, hopper
empty, outflow blocked!

Hopper empty

Outlet blocked
48 Right dosing error, hopper
empty, outflow blocked!

Hopper empty

Outlet blocked
49 Idle measurement implausi-
ble. EMC control deactivated!

Defective sensor

Defective transmission
50 Idle measurement impossi-
ble. EMC control deactivated!
PTO speed not permanently stable
51 Hopper empty. The kg level sensor emits an “empty” notifi-
cation. The entered value is undercut.
52 Error at hopper cover Actuator overloaded
53 Defect at hopper cover Defective TELIMAT actuator
54 Change TELIMAT position The TEILMAT position does not correspond
to the state notified by GPS Control.
75 This disc type requires a
modification on theTELIMAT
device. Please follow the-
mounting instructions!
S1 disk is mounted and the machine is
equipped with TELIMAT. Spreading errors
possible during limited border spreading.

This disk type facilitates TELIMAT ap-
paratus mounting.
No. Message on display Meaning

Possible cause