Rauch QUANTRON-A AXIS-M 20 Q, Instruction Manual

Page: 52 / 116

Operation QUANTRON-A 4
46
4.6.6 Calibration
In this menu, you can determine the flow factor based on a calibration and save
it in the control unit.
Carry out the calibration test:

before spreading for the first time.

If the fertiliser quality has changed significantly (moisture, high
dust content, cracked grain).

if a new fertiliser type is used.
The calibration test must be carried out with engaged PTO shaft at a standstill or
during travel over a test section.

Remove both spreading discs.

Set the drop point to calibration position (AGP 0).
Entering the working speed:
1.
Open the Fertiliser settings > Start calibration menu.
2. Enter the average working speed.
This value is required to calculate the slider position during calibration.
3. Press the Enter key .
 The new value is saved in the control unit.
 The Move to drop point (AXIS only) alarm message appears in the dis-
play.
4. Press the Start/Stop key.
 The drop point is activated.
 The alarm is cleared.
 The Prepare calibration test operating screen is displayed.
NOTICE
The Calibration menu is locked for the M EMC function and in the
AUTO km/h + AUTO kg operating mode. This menu item is inactive.
n
CAUTION
Risk of injury due to automatic drop point adjustment
With machines equipped with electrical drop point actuators,
the
Move to drop point alarm message appears. When the
Start/Stop function key is pressed, the drop point automatically
moves to the pre-set value using the electrical actuating cylinders.
This may cause injury and material damage.
 Before pressing Start/Stop , ensure that nobody is present
in the danger zone of the machine.