WARNING!
Risk of accident due to improperly carried out change of wheels
Improper change of wheels at the machine may lead to severe accidents and personal injury.
u
Change wheels only if the machine is empty and coupled to the tractor.
u
For wheel change, the machine has to be parked on even and solid ground.
Requirements:
•
Use a jack with a minimum load rating of
5 tons
.
•
For tightening the wheel nuts, use a torque wrench.
Lifting jack positioning:
•
The correct lifting jack application points
are marked with an illustration.
•
Position the lifting jack in such a way that
the support surface cannot slip (e.g., using
a fitting piece of wood or rubber block).
u
Additionally secure the lifting chuck against
slipping.
u
For a wheel change on the right side in
direction of travel, position the lifting jack
on the right [2] under the sticker.
u
For a wheel change on the left side in
direction of travel, position the lifting jack
on the left [1] under the sticker.
Fig. 71: Lifting jack application points
Wheel assembly
u
Prior to assembly, clean the contact surface of the wheel at the hub.
u
Prior to assembly, check the wheel nuts and bolts. Replace damaged, stuck or corroded wheel
nuts or bolts.
u
Tighten all wheel nuts in steps and diagonally with a torque wench.
w
Tighten the wheel nuts with a tightening torque of
510 Nm
.
w
Screw on all
10
wheel nuts per wheel and tighten them.
9. Maintenance and service
104
5903360
AXENT 90.1
Summary of Contents for AXENT 90.1
Page 119: ...12 Appendix 12 Appendix AXENT 90 1 5903360 119...
Page 126: ......
