219
Machine No. from 10005200
EN
5.9
Adjusting the axle
5.10
Adjusting the axle stop
Actuating the switch moves the axle forwards or backwards:
1 = Axle moves forwards
2 = Axle moves backwards
1
2
Information
• Adjusting the axle can change the weight at the attachment and the lifting force.
• The axle can only be moved if the machine has been engaged.
Avertissement
The machine may suddenly trap the operator or third persons, cause them to fall over or
run them over.
• Danger of crushing due to the adjustable axle.
• When adjusting the axle, your limbs can be crushed or severed.
• When adjusting the axle, ensure that nobody is in the danger zone.
Axle stop at left side - adjustment
to rear.
• Loosen screw connection (1).
• Turn adjusting screw (2.1)
clockwise as far as it will go.
• Move axle to required position.
• Turn adjusting screw (2.2) as far
as limit switch (3).
• Tighten screw connection (1).
Axle stop at right side - adjustment
to front.
• Same procedure as for left side
axle stop.
1
3
2.1
2.2
Note
• After a wheel change or a change of attachment, the axle adjustment end stop must be
checked.
Warning
The machine may suddenly trap the operator or third persons, cause them to fall over or
run them over.
• The axle stops must be adjusted so that no collision can occur in the axle adjusting area.
• When adjusting the axle, your limbs can be crushed or severed.
• When adjusting the axle, ensure that nobody is in the danger zone.
