R&S SMW-K106, User Manual

Page: 67 / 455

Space Vehicle Configuration Satellite Navigation
67 User Manual 1178.6379.02 ─ 01
3. Select "GNSS > Simulation Configuration > Satellites".
4. Select "GLONASS > SV# > SV Config".
5. In the "SV Configuration" dialog, select "Signals Configuration" .
6. To generate a continuous wave signal, send on the GLONASS frequency, select:
a) "Primary Code > Off"
b) "Nav. Msg. Control > Off"
c) "Meander Sequence > Off"
d) "Time Sequence > Off"
7. For a Galileo satellite, you achieve the same effect as follows:
a) "Primary Code > Off"
b) "Secondary Code > Off"
c) "Nav. Msg. Control > Off"
8. To apply the modulation control settings of the current satellite to other SV ID,
select for example "SV-ID = All" and "Copy Modulation Control To"
Available modulation control settings depend on the GNSS system and selected
RF band.
See also:
●
Chapter 19.10, "Signals and Power Configuration per Satellite" , on page 259
Settings
SV signal configuration table .........................................................................................68
└ Signal State .....................................................................................................68
└ Signal Component .......................................................................................... 68
└ Primary Code .................................................................................................. 68
└ Seconadry Code ............................................................................................. 68
└ Nav Msg Control ............................................................................................. 69
└ Nav Msg Type, Pattern, Data List ................................................................... 69
└ Nav Msg Content, Config ................................................................................70
Modulation Control Settings