R&S ESW-K58, User Manual

Page: 32 / 103

Configuration
R&S
®
ESW-K58
32 User Manual 1179.0880.02 ─ 03
Note: The "External Trigger 1" softkey automatically selects the trigger signal from the
"TRIGGER 1 INPUT" connector on the front panel.
For details, see the "Instrument Tour" chapter in the R&S
ESW Getting Started manual.
"External Trigger 1"
Trigger signal from the "TRIGGER 1 INPUT" connector.
"External Trigger 2"
Trigger signal from the "TRIGGER 2 INPUT / OUTPUT" connector.
"External Trigger 3"
Trigger signal from the "TRIGGER 3 INPUT / OUTPUT" connector on
the rear panel.
Remote command:
TRIGger<tp>[:SEQuence]:SOURce
on page 79
Trigger Level
Defines the trigger level for the specified trigger source.
For details on supported trigger levels, see the instrument data sheet.
Remote command:
TRIGger<tp>[:SEQuence]:LEVel[:EXTernal]
on page 79
Trigger Offset
Defines the time offset between the trigger event and the start of the measurement.
Offset > 0: Start of the measurement is delayed
Offset < 0: Measurement starts earlier (pretrigger)
Remote command:
TRIGger<tp>[:SEQuence]:HOLDoff[:TIME]
on page 80
Drop-Out Time
Defines the time that the input signal must stay below the trigger level before triggering
again.
Remote command:
TRIGger[:SEQuence]:DTIMe
on page 80
Slope
For all trigger sources except time, you can define whether triggering occurs when the
signal rises to the trigger level or falls down to it.
Remote command:
TRIGger<tp>[:SEQuence]:SLOPe
on page 81
Trigger Holdoff
Defines the minimum time (in seconds) that must pass between two trigger events.
Trigger events that occur during the holdoff time are ignored.
Remote command:
TRIGger[:SEQuence]:IFPower:HOLDoff
on page 81
Trigger