165
ParkSense will retain the last system state
(enabled or disabled) from the last ignition
cycle when the ignition is changed to the ON/
RUN position.
ParkSense can be active only when the gear
selector is in REVERSE or DRIVE. If Park
-
Sense is enabled at one of these gear
selector positions, the system will remain
active until the vehicle speed is increased to
approximately 7 mph (11 km/h) or above. A
warning will appear in the instrument cluster
display when the vehicle is in REVERSE,
indicating the vehicle is above ParkSense
operating speed. The system will become
active again if the vehicle speed is decreased
to speeds less than approximately 6 mph
(9 km/h).
ParkSense Sensors
The four ParkSense sensors, located in the
rear fascia/bumper, monitor the area behind
the vehicle that is within the sensors’ field of
view.
The sensors can detect obstacles from
approximately 18 inches (45 cm) up to
79 inches (200 cm) from the rear fascia/
bumper in the horizontal direction,
depending on the location, type and orienta
-
tion of the obstacle.
NOTE:
If equipped as a dually, the ParkSense
system has six rear sensors to assist in detec
-
tion around the dually flares.
The six ParkSense sensors, located in the
front fascia/bumper, monitor the area in
front of the vehicle that is within the sensors’
field of view. The sensors can detect obsta
-
cles from approximately 12 inches (30 cm)
up to 47 inches (120 cm) from the front
fascia/bumper in the horizontal direction,
depending on the location, type and orienta
-
tion of the obstacle.
Enabling And Disabling Front And/Or
Rear ParkSense
Front ParkSense can be enabled and
disabled with the Front ParkSense switch.
Rear ParkSense can be enabled and disabled
with the Rear ParkSense switch.
When the gear selector is moved to
REVERSE and the Front or Rear
system is disabled, the instrument
cluster display will show the “Off”
message. This vehicle graphic will be
displayed for as long as the vehicle is in
REVERSE.
The Front or Rear ParkSense switch LED will
be on when Front or Rear ParkSense is
disabled or requires service. The Front or
Rear ParkSense switch LED will be off when
the Front or Rear system is enabled. If the
Front or Rear ParkSense switch is pushed,
and the system requires service, the Front or
Rear ParkSense switch LED will blink
momentarily, and then the LED will be on.
PARKVIEW REAR BACK UP
CAMERA
Your vehicle may be equipped with the
ParkView Rear Back Up Camera that allows
you to see a image of the rear surroundings
of your vehicle whenever the gear selector is
put into REVERSE or whenever it is initiated
through the "Backup Camera" button in the
"Controls" menu. Whenever the gear selector
is put into REVERSE, the image will be
displayed in the rearview mirror display (if
equipped) or Uconnect screen (if equipped).
If the image is displayed in the Uconnect
screen, a caution note to “check entire
surroundings” will display across the top of
the screen. After five seconds this note will
disappear.
2019_RAM_2500_3500_UG_USA=GUID-8BBFE451-BF24-4E82-808A-AE2460D39A05=1=en=.book Page 165
Summary of Contents for 2500 2019
Page 1: ...2019 USER GUIDE RAM 2500 3500...
Page 330: ......