RAM Commercial ProMaster 2024, Owner'S Manual, Page: 43 / 284

Swivel Seat — If Equipped
The swivel seat lever is located at the lower front
inboard side of the seat. The seat may be turned
through 180° toward the seat on the opposite side and
approximately 35° toward the door. The seat may be
locked in the driving position or at the 180° position. To
swivel the seat, pull the swivel seat inboard lever out-
ward, turn the seat to the desired position and release
the lever.
If the vehicle is equipped with interlocking swivel seats,
the seats must be locked in the facing forward position
while driving. If the seats are not in the correct position,
a warning will appear in the instrument cluster display.
If the driver or the passenger seats are not locked in
the facing forward position before the first vehicle
movement, shifting out of park is not allowed until the
seats are both locked in the facing forward position.
When the seats are not in the right position and the
first vehicle movement after ignition START is
attempted, a chime and a message will appear in the
instrument cluster display. Rotate and lock the swivel
seats in the correct position before trying again.
If the driver or the passenger seats are not locked in
the facing forward position during movement of the
vehicle, a message will appear in the instrument cluster
display and an intermittent chime will sound until key-
off or until the swivel seats are locked in the facing for-
ward position. Stop and move the swivel seats in the
correct position before proceeding.
If a fault is present in the system and it is not possible
to check the correct position of the swivel seats, a mes-
sage and the generic warning light appears in the
instrument cluster display to inform about the failure. In
these conditions, check the status of the swivel seats
and do not drive the vehicle until the swivel seats are
locked in the facing forward position.
Jump Seat (BEV Models) — If Equipped
The jump seat is available for passenger use. To lower
the seat, pull down on the bottom of the seat. The seat
will return to stowed position once pressure is removed
from seat bottom.
For seat belt operation instructions, follow steps shown
in Lap/Shoulder Belt Operating Instructions
page 168.
No child restraint should ever be placed in the jump
seat.
WARNING!
The jump seat is not designed to be used with a child
safety seat or a booster seat.
HEATED SEATS — IF EQUIPPED
On some models, the front driver and pas-
senger seats may be equipped with heaters
in both the seat cushions and seatbacks.
The controls for the front heated seats are
located on the lower outboard side of the seat.
Swivel Seat Lever
Lowering The Jump Seat
GETTING TO KNOW YOUR VEHICLE 41
2