RAM Commercial ProMaster 2024, Owner'S Manual, Page: 100 / 284

ACTIVE SPEED LIMITER — IF EQUIPPED
The Active Speed Limiter button is positioned on the
right side of the steering wheel.
This feature allows you to program the maximum speed
of travel for your vehicle.
NOTE:
The Active Speed Limiter can be set with the vehicle
stationary or in motion.
ACTIVATION
To activate the feature, push the Active Speed Limiter
button located on the right side of the steering wheel. A
message will appear along with an indicator light in the
instrument cluster display to signal that Active Speed
Limiter has been activated.
After the Active Speed Limiter on/off button has been
pushed, you must press the SET (+) or SET (–) button to
set the target speed (or RES button when there is
already a previously set target).
Push the SET (+) or SET (–) button to raise and lower
the target speed to the desired value. Pushing and
holding down the SET (+) or SET (–) button will
increase/decrease the speed value by increments of
5 mph (5 km/h).
Each time that Active Speed Limiter is activated, it will
be set to the last programmed value from the previous
activation.
NOTE:
The Cruise Control (if equipped) and Adaptive Cruise
Control (if equipped) systems will be unavailable while
the Active Speed Limiter is in use.
EXCEEDING THE SET SPEED
By fully pressing the accelerator pedal, the pro-
grammed maximum speed can be exceeded while the
device is active.
In the event that the Active Speed Limiter set value is
exceeded manually with a driver acceleration, an
audible indicator will sound. The indicator light will rap-
idly flash, and a message will appear in the instrument
cluster display.
The feature will remain disabled until the vehicle speed
drops below the set Active Speed Limiter value, where it
will reactivate automatically.
DEACTIVATION
To turn off Active Speed Limiter, push the Active Speed
Limiter button on the right side of the steering wheel. A
message will appear in the instrument cluster display to
confirm that the feature has been turned off. You can
also deactivate Active Speed Limiter by pressing the
CANC button. In this case, the system is not completely
turned off, and the driver can reactivate the Active
Speed Limiter by pressing the RES button.
INTELLIGENT SPEED ASSIST (ISA) —
IF EQUIPPED
The Intelligent Speed Assist (ISA) system
combines the Active Speed Limiter and Traf-
fic Sign Assist (TSA) systems to automatically
adjust the maximum speed of the vehicle
based on detected traffic signs.
ACTIVATION
To activate the feature, make sure the Traffic Sign
Assist (TSA) system is enabled within Uconnect Settings
page 136, then push the Active Speed Limiter but-
ton located on the right side of the steering wheel. The
message “Ready” will appear along with a white indica-
tor light in the instrument cluster display to signal that
the system has been activated.
While the system is in the “Ready” state, the driver
must press the SET (+), SET (–), or RES button to
engage the system. When the system is fully engaged
and detects the current speed limit using the TSA sys-
tem, the message in the instrument cluster display will
indicate the new detected speed limit by suggesting the
driver to press "RES" to accept it.
If the detected speed sign is greater than the current
set speed, an up arrow will be displayed too. If the
detected speed sign is lower than the current set
speed, a down arrow will be displayed instead. If the
driver accepts the new suggested speed sign, the indi-
cator light will change to green.
Active Speed Limiter Button
98 STARTING AND OPERATING