RAM Commercial ProMaster 2024, Owner'S Manual, Page: 127 / 284

When the vehicle is shifted out of REVERSE with cam-
era delay turned off, the Surround View system is exited
and the last known screen appears again.
Whenever the Rear View Camera image is activated
through the Back Up Camera button in the Controls
menu, and the vehicle speed is greater than, or equal
to, 8 mph (13 km/h), a display timer for the image is
initiated. The image will continue to be displayed until
the display timer exceeds 10 seconds.
NOTE:
•
If the vehicle speed remains below 8 mph
(13 km/h), the Rear View Camera image will be dis-
played continuously until deactivated via the touch-
screen X button, the transmission is shifted into
PARK, or the ignition is placed in the OFF position.
•
The touchscreen X button to disable display of the
camera image is made available ONLY when the
vehicle is not in REVERSE.
When enabled, active guidelines are overlaid on the
image to illustrate the width of the vehicle, including
the side view mirrors and its projected back up path
based on the steering wheel position.
Different colored zones indicate the distance to the rear
of the vehicle.
The following table shows the approximate distances
for each zone:
Zone
Distance To The Rear Of
The Vehicle
Red 0 - 1 ft (0 - 30 cm)
Yellow 1 ft - 6.5 ft (30 cm - 2 m)
Green
6.5 ft or greater
(2 m or greater)
Modes Of Operation
Manual activation of the Surround View system is
selected by pressing the Surround View Camera button
located in the Controls screen within the Uconnect
system.
Top View
The Top View will show in the Uconnect system with
Rear View or Front View in a split screen display. There
are integrated ParkSense arcs in the image at the front
and rear of the vehicle. The arcs will change color from
yellow to red corresponding the distance zones to the
oncoming object.
NOTE:
•
Front tires will be in image when the tires are
turned.
•
Due to wide angle cameras in the mirrors, the image
will appear distorted.
•
Top View will show which sliding doors are open.
•
Open front doors will remove outside image.
Rear View
This is the default view of the system in
REVERSE and is always paired with the Top
View of the vehicle with optional active
guidelines for the projected path when
enabled.
Rear Cross Path View
Pressing the Rear Cross Path button will give
the driver a wider angle view of the Rear
View. The Top View will be disabled when this
is selected.
Front View
The Front View will show you what is immedi-
ately in front of the vehicle and is always
paired with the Top View of the vehicle.
Front Cross Path View
Pressing the Front Cross Path button will give
the driver a wider angle view of the Front
View. The Top View will be disabled when this
is selected.
Back Up Camera View
Pressing the Back Up Camera button will
provide a full screen rear view.
NOTE:
If the Back Up Camera was selected through the Sur-
round View Camera menu, exiting out of screen display
will return to the Surround View menu. If the Back Up
Camera was manually activated through the Controls
menu of the Uconnect system, exiting out of the display
screen will return to the Controls menu.
Surround View Camera View
STARTING AND OPERATING 125
4