RAM Commercial ProMaster 2024, Owner'S Manual, Page: 113 / 284

The Active Driving Assist system may have limited or
reduced functionality when one of the following condi-
tions occur:
•
The vehicle’s radar sensors and/or forward facing
camera is damaged, covered, misaligned,
obstructed (e.g. by mud, ice, snow, etc.), or works in
low sun conditions
•
If the suspension alignment is not correct, if the
vehicle is modified (e.g. lifting or lowering the sus-
pension, installing different sized wheels or tires)
•
Driving near highway toll booths
NOTE:
If damage to the windshield occurs, have the wind-
shield replaced by an authorized dealer as soon as
possible.
PARKSENSE FRONT/REAR PARK ASSIST —
IF EQUIPPED
The ParkSense Park Assist system provides visual and
audible indications of the distance between the rear,
and if equipped, the front fascia/bumper and a
detected obstacle when backing up or moving forward
(e.g. during a parking maneuver). For limitations of the
system (e.g. during a parking maneuver), see
page 114.
NOTE:
•
The system is designed to assist the driver and not
to substitute the driver.
•
The driver must stay in full control of the vehicle's
acceleration and braking and is responsible for con-
trolling the vehicle's movements.
ParkSense will retain the last system state (enabled or
disabled) from the last ignition cycle when the ignition
is placed in the ON/RUN position.
ParkSense is active when the gear selector is shifted to
REVERSE or to a forward gear and an obstacle is
detected, as long as the system is on. When the gear
selector shifted to NEUTRAL or PARK, the system
becomes inactive. When the vehicle is moving forward,
the system will remain active until the vehicle speed
remains below approximately 8 mph (13 km/h). Reduc-
ing the speed approximately below 7 mph (11 km/h),
the system will come back active. When the vehicle is
moving in REVERSE, the system will remain active as
long as the vehicle speed remains below the maximum
operating speed of 7 mph (11 km/h). When the maxi-
mum speed limit is exceeded, the system is disabled
and the ParkSense switch LED will illuminate. The sys-
tem will become active again if the vehicle speed
reduces below approximately 6 mph (9 km/h).
Interaction With Trailer Towing
The Park Assist system is automatically deactivated
when a trailer is hitched to the vehicle. The system will
be automatically activated as soon as the trailer is
removed.
PARKSENSE SENSORS
The six ParkSense sensors (four when vehicle is not
equipped with front sensors), located in the rear fascia/
bumper, and the six ParkSense sensors located in the
front fascia/bumper, monitor the area in front and
behind the vehicle that is within the sensors’ field of
view. The front sensors detect obstacles from approxi-
mately 12 inches (30 cm) up to 39 inches (100 cm)
from the front fascia/bumper. The rear sensors can
detect obstacles from approximately 12 inches (30 cm)
up to 55 inches (140 cm) from the center of the rear
fascia/bumper and up to 24 inches (60 cm) from the
corners of the rear fascia/bumper. These distances
depend on the location, type and orientation of the
obstacle in the horizontal direction.
If several obstacles are detected, the ParkSense sys-
tem indicates the nearest obstacle.
The minimum height of a detectable obstacle corre-
sponds to the maximum height of an obstacle that
would clear the underside of the vehicle during the
parking maneuver.
PARKSENSE WARNING DISPLAY
The ParkSense Warning screen will only be displayed if
“Sound and Display” is selected in the Uconnect system
page 136.
The ParkSense Warning screen is located within the
instrument cluster display
page 69. It provides
visual warnings to indicate the distance between the
rear fascia/bumper and/or front fascia/bumper and
the detected obstacle.
Rear Park Assist Sensors Location
STARTING AND OPERATING 111
4