Continued on next page:
*NOTE: If assembling Pod A to conform to Australian standards, refer to
installation instructions on pages 119-120 instead of this Step.
*NOTE: From this step on, construction methods are the same with or without the Wood Roof.
All steps from this point on will be shown as built with the Wood Roof.
*NOTE: When installing ADA Transfer Handle Upright (6739) and ADA Transfer Upright (6787),
ensure they are spaced appropriately. All Uprights should measure 32" from
outside to outside (as shown in Inset A).
1. Attach ADA Transfer Handle Upright
(6739)
and ADA Transfer Upright
(6787)
to previously installed 8
Hole Facia
(4811)
and previously installed 6 Hole Facia
(4732)
(as shown in Inset B)
using 3/8"
Hardware
(H3) (H116)
.
2. Position 4 Hole Facia
(4693)
(as shown in Detail A) with offset holes down and attach to ADA
Transfer Handle Upright
(6739)
and ADA Transfer Upright
(6787)
using 3/8" Hardware
(H3) (H116)
.
The top of 4 Hole Facia
(4693)
should be flush with the top of 8 Hole Facia
(4811)
and 6 Hole Facia
(4732)
.
3. Attach 2 Hole Facias
(3901)
(in two locations shown) to Uprights using 3/8" Hardware
(H3) (H116)
. 2
Hole Facias
(3901)
should rest directly on top of the Facias below.
4. Place ADA Support Facias
(4847)
directly on top of 6 Hole Facia
(4732)
and 8 Hole Facia
(4811)
and
attach to Uprights
(6739) (6787) (6798) (6799)
using 3/8" Hardware
(H3) (H116)
.
5. Place 6 Hole Facias
(4732)
directly on top of (approximately
20 5/8"
up from the bottom of Uprights
as shown in Inset A) ADA Support Facias
(4847)
and attach to Uprights
(6739) (6787) (6798) (6799)
using 3/8" Hardware
(H3)
(H116)
. Orient 6 Hole Facias
(4732)
with offset holes nearest the edge
down (as shown in Detail B).
*NOTE: Using a level, square, and a tape measure, check to ensure the structure is square
and level.
37
Step 5
Facia & Step Support Assembly
*US Design only