Continued on next page:
*ATTENTION: Commercial units are designed for construction with the Wood Roof option but
can be constructed without. Complete the required part modifications, per
Steps 2 and 4, prior to assembly. Be sure to fully read and follow directions
below.
1. Make the following modifications to ML Corner Uprights
(6799)
and ML Center Uprights
(6798)
:
Cut two ML Corner Upright (6799) to 86"
•
Cut one ML Corner Upright (6799) to 77"
•
Cut one ML Center Upright (6799) to 91 3/4"
•
Cut one ML Center Upright (6798) to 86"
•
2. Router, sand, and stain cut surfaces.
3. Attach Commercial Ground Runners
(6796)
to ML Corner Uprights
(6799)
and ML Center Uprights
(6798)
using 3/4" Hardware
(H5)
and 1/2" Hardware
(H4) (H12) (H18) (H29) (H71)
. Do not fully
tighten hardware at this time.
4. Measure up
12 5/8"
and
85"
on ML Corner Uprights
(6799)
(as shown in Inset A) and attach 6 Hole
Facias
(4732)
to ML Corner Uprights
(6799)
and ML Center Uprights
(6798)
using 3/8" Hardware
(H3)
(H116)
. 6 Hole Facias
(4732)
should have offset holes farthest from edge up (as shown in
Details A & B).
5. Square each wall assembly using a tape measure, level, and square.
6. Finish tightening Hardware from #3.
31
Step 2
Pod A Wall Support Assembly
(without Wood Roof)