PROGRAMMING THE AREARAE
4-24
4.6.4 Enable/Disable Datalog
You can choose to enable or disable the datalogging function
on each individual sensor. This allows selective logging of
certain sensor readings of interest.
1. When “Enable / Disable Datalog?” appears, press [Y/+].
The display shows the entire installed sensor in the
monitor. A previously selected sensor to be datalogged is
marked with an “*” next to the sensor name. The cursor is
blinking at the first sensor location. Press [Y/+] to enable
the datalogging for the sensor and [N/-] to disable the
datalogging.
TOX1
VOC
TOX2
CO*
VOC*
H2S*
LEL* pick
OXY*
LEL
OXY
TOX1
VOC
Gamma
CO*
VOC*
Gmm*
LEL*
pick
OXY*
LEL
OXY
AreaRAE
AreaRAE Gamma
2. Press [MODE] momentarily to move from one sensor
location to the next one. Repeat Step 2 until all the sensors
that need to be datalogged are selected. Press and hold
[MODE] for 1 second to save the new sensor selection.
3. The display shows “Save?” To confirm the new selection,
press [Y/+] to accept the change. Press [N/-] or [MODE] to
discard the change and return to the first datalog submenu.
