D6600 NetCom
Communication System Overview
D6600 NetCom System Guide
46542C
Page 12
© 2001 Radionics
Figure 2 shows a D6600 NetCom System
using any manufacturer’s alarm panel,
C900TTL-E Dialer Capture
Module/network adapters, D6600
Receiver, and D6680 Network Adapters.
The other type of network interface for
Alarm Panels is the D9133TTL-X Serial
Interface. The D9133TTL is designed for
use with Radionics 9000 Series control
panels ONLY. No other Alarm Panel will
function with the D9133TTL. The
D9133TTL and the Radionics 9000
Series panels communicate using the
SDI bus rather than the dialer capture
method used by the C900TTL. The
Radionics D9133TTL Serial Interfaces
are specific to the type of network and
application to which you will be
connecting.
Radionics model
number
Application description
D9133TTL-E
Radionics 9000 series Serial
Interface, Ethernet networks
D9133TTL-TR
Radionics 9000 series Serial
Interface, Token Ring
networks
Table 5: D9133TTL Part Numbers
Ethernet HUB
O
F
F
1
2
3
4
5
6
7
8
9
1
0
PA NEL
TELC O
C
OU T4
OUT1
O UT2
OUT 3
IN 3
I N2
IN 1
C
I -12V+
D6680
D6680
COM4
COM1 (optional)
D6600
C900TTL-E
HOST PC
ETHERNET
CONTROL PANEL
TELCO Connection
To Panel
ANY
MANUFACTURER'S
ALARM
PANEL
D6200 Programming
Administrative
Software
Ethernet NIC
Figure 2: D6600 NetCom System Connection Diagram using
C900TTL & any Alarm Panel
The figure at the right is a diagram of a D6600
NetCom System using Radionics 9000 Series
panels, D9133TTL-E Serial Interface, D6600
Receiver, and D6680 Network Adapters.
The Radionics D6200 Programming/
Administration Software is a D6600
programming utility that is designed to work
over a network connection. Each network
interface device (D6680 Network Adapter,
D9133TTL Serial Interface, or C900TTL Dialer
Capture Module/network adapters) must be
added to the ARP table (see
Section 5.6
Initial Assignment of the IP Address
using ARP.EXE
) then configured through a
Telnet session (See
Section 5.8
Using
Telnet to Finish the Configuration
) in order to
configure each device before network
communications will function.
See the appropriate configuration information
for the device that you are setting up (D6680,
D9133TTL, or C900TTL) in this manual.
ARP stands for Address Resolution Protocol
and is used to convert an IP address into a
hardware address. It is installed into the
Windows directory during the installation of the
D6200 software.
D6680
D6680
COM4
COM1 (optional)
Ethernet HUB
D6600
D9133TTL-E
(Ethernet)
HOST PC
Ethernet
CONTROL PANEL
(9000 Series)
SDI Bus
1 2 4 8
R
Ethernet NIC
D6200 Programming
Administrative
Software
Figure 3: D6600 NetCom System Connection Diagram
using D9133TTL and Radionics 9000 Series Panel