D6600 NetCom
Configuration of the D6680 Network Adapter(s)
D6600 NetCom System Guide
© 2001 Radionics
Page 25
46542C
8.
The program will prompt you to press [ENTER] by
displaying "Press Enter to go into setup mode."
Press [ENTER].
If you do not press [ENTER] within 5 seconds of seeing the above message, you
will be disconnected. If this occurs, simply return to Step 1 (in this section).
9.
If you pressed [ENTER] within 5
seconds, then you should see the
following screen (See Figure 13).
Figure 13: Telnet session
10. Press [0] + [ENTER] to set up the basic Server Configuration. You are now required to enter the desired
IP address.
If the D6680 Network Adapter has been programmed with an IP
address in the past, it will be displayed in parentheses.
For example, if this D6680 Network Adapter were originally programmed to IP address 190.200.128.152,
we would be changing it to address 190.200.128.220.
11. To properly program the IP address
190.200.128.220, the following keys
would be entered:
190
[ENTER]
200
[ENTER]
128
[ENTER]
220
[ENTER]
Note:
REMEMBER THAT THE IP ADDRESS USED IN THIS EXAMPLE WILL NOT BE THE SAME AS THE
NUMBERS YOU ARE USING. THIS IS FOR DEMONSTRATION ONLY!
12. When asked to set the Gateway address,
type
N
[ENTER] or
Y
[gateway address]
[ENTER]
Figure 14: Telnet session – Gateway Address
13. If the Netmask needs to be changed from the default, enter the number of bits that correspond to the
Netmask your network is using (see Table 8).
See your network administrator for more information.
Press [ENTER] after entering the correct number of bits for the Netmask.
