D6600 NetCom
C900TTL-X Configuration
D6600 NetCom System Guide
46542C
Page 80
© 2001 Radionics
11. When asked to set the
Gateway address.
type
N
[ENTER] or
Y
[gateway address]
[ENTER]
Figure 39: Telnet Session – Gateway Address
12. If the Netmask needs to be changed from the default, enter the number of bits that correspond to the
Netmask your network is using.
See your network administrator for more information.
Press [ENTER] after entering the correct number of bits for the Netmask.
Number of
Host Bits
Netmask
Number of
Host Bits
Netmask
Number of
Host Bits
Netmask
1
255.255.255.254
11
255.255.248.0
21
255.224.0.0
2
255.255.255.252
12
255.255.240.0
22
255.192.0.0
3
255.255.255.248
13
255.255.224.0
23
255.128.0.0
4
255.255.255.240
14
255.255.192.0
24
255.0.0.0
5
255.255.255.224
15
255.255.128.0
25
254.0.0.0
6
255.255.255.192
16
255.255.0.0
26
252.0.0.0
7
255.255.255.128
17
255.254.0.0
27
248.0.0.0
8
255.255.255.0
18
255.252.0.0
28
240.0.0.0
9
255.255.254.0
19
255.248.0.0
29
224.0.0.0
10
255.255.252.0
20
255.240.0.0
30
192.0.0.0
31
128.0.0.0
Table 25: Netmask Address
13. You will be prompted to change the
Telnet password, press [N] for the
default of "No". This screen will now
show the Setup Mode screen.
Be careful NOT to enter a password into the C900TTL-X by accident or select [Y] to change the
password. If you do, do not lose the password. Otherwise, you will not be able to re-enter a TELNET
programming session with the C900TTL-X. The unit will have to be sent back to the factory and
reconditioned before it will be able to receive another TELNET session.
14. Now press [1] [ENTER] to go into setup Channel 1
configuration. The following will be displayed:
You must set the baud rate of the C900 to 9600.
Enter
9600
[ENTER] to change it.
15. You should then see:
Press Enter to accept the default of (4C). If it doesn't show that,
type
4C
[ENTER] to change it.
