Source
: Press and hold the ENT key to enter the input source selection menu. Scroll up or
down to the desired category and press ENT to select the corresponding input source
Weight:
Normal range is a value between ± 100% will be zoomed to the gimbal operation.
If you enter a negative value, for example -100% means reverse the output. Note that channel
inversion should not use negative values on the Inputs page, and to reverse channels should be
reversed on the Outputs page.
Offset
: Midpoint offset setting
Curve
: Curve settings
Diff
Adjust the travel amount on one side with the midpoint as the boundary
Expo
Expo curve setting. Increasing a positive value will make the gimbal smoother and
smoother when approaching the midpoint, while increasing a negative value will
make the gimbal more acute when approaching the midpoint.
Func
Preset
function
X>0
Func
Preset function
X<0
Positions above 0 (midpoint) follow the gimbal output, operations
below the midpoint are all fixed to the midpoint value of 0
|X|
The opposite of the previous one
f>0
Absolute values, negative values less than the midpoint will always
become positive values, and the actual performance is a V-shaped
curve
f<0
Below the midpoint 0 is fixed at midpoint 0, above the midpoint is fixed
at 100, the actual performance is that the gimbal becomes 0 and 100 to
switch, there is no intermediate process
|f|
The opposite of the previous one
Cstm
Call custom curve (CV1-CV32), custom curve is set in curve page CURVE
