and + 100% to switch. There is no intermediate process.
Diff
Adjust the stroke amount on one side with the midpoint as the boundary
Mode
: Select the corresponding flight mode, and the output trimming value that affects
this entry can be set by the flight mode entry
Switch
: Select the switch to activate this item (Note: This setting is added to this item to
add multiple lines of different settings to switch, if there is only one line setting, do not set
the activation switch, otherwise the switch will cause this item to be completely invalid).
Warning
: Set the alert tone
Multiplex
: Superposition method, output after superimposing with the value of the
previous stroke amount
Add: Additive superposition, the current value is added to the value of the previous
line and output
Multiply: multiplication, the current value is multiplied by the value of the previous line
and output
Replace: direct replacement, the value of the previous line is directly replaced by the
value of this line
The combination of these operations allows the creation of complex mathematical
operations and is often considered one of the biggest benefits of using EdgeTX.
Delay Up/Dn
: The response of the output can be delayed as the input changes. (In seconds).
Slow Up/Dn
: Regarding input changes, the response of the output can be slowed. For
example, slow speed can be used to slow down retraction driven by a normal proportional
servo. The output will cover the time in seconds from 100 to + 100%.
3.4.6. Output（Outputs）
Total output page, final channel output overall settings
To quickly set the high/low and center points, press enter on the desired channel to open the
quick-access menu
