RadioLink Electronic Ltd
9
Binding the transmitter to the receiver is essential. Otherwise, the aircraft cannot take off.
RadioLink receivers R12DSM/R6DSM are compatible with transmitters AT9/AT9S/AT10/AT10II while
R8FM is compatible with transmitter T8FB.
Binding steps of all RadioLink transmitters and receivers are the same as follow:
（
1
）
Put the transmitter and the receiver together within 1 meter.
（
2
）
Power on the transmitter and the receiver. The receiver will bind to the closest transmitter.
（
3
）
Press the ID SET on the side of the receiver for more than 1s, the flashing LED means binding starts.
（
4
）
When LED stops flashing, binding is complete.
When binding is done, please check if the receiver change to SBUS/PPM output . Generally we use
SBUS signal. LED on all receivers from RadioLink is blue/purple means SBUS signal while red means PWM
signal. Pilots can short press the binding code twice within 1s to switch the signals output of the receiver.
2.2.2 Installation of Mission Planner
To run the Mission Planner installation, NET. Framework from Microsoft is needed. Link is as below
https://www.microsoft.com/net/download/thank-you/net462
Download link of Mini Pix Mission Planner:
http://www.RadioLink.com.cn/firmware/MissionPlanner/MissionPlanner-latest.exe
Before setting the parameter, please install the Mission Planner first.
Steps to install the Mission Planner, please refer to the video as below:
https://www.youtube.com/watch?v=twW9CaRlj-U&t=1159s
(Starting from 13:00)
