62
EN
0811000001
SETZEN
T2001004
(1
1.08)
ACHTUNG: Vor Öffnen des Gerätes Netzstecker ziehen!
230V ~ 50 Hz, 200 W, KB. 4 min.
Lampe 230V, max. 40W E14
Zugkraft 550N, - 5° bis + 40°C
Nur für trockene Räume
Art.-Nr.: RP-S4-550N-1
RolloPort S4
RolloPort S4
Carry out reference runs
„Close“ reference run
1.
Press red button.
The lamp on the opener flashes and the garage door closes and
runs to the lower end point.
„Open“ reference run
2.
Give the button one short press again.
The garage door opens and runs to the upper end point.
NOTE
Valid reference runs are acknowledged with short-term rapid flashing of the
lamp. The reference runs are only valid if the opener runs in each case
from one end point to the other.
3.
Repeat both reference runs again twice (a total of 3 reference
runs are necessary in each direction).
4.
If all reference runs have been completed and are valid,
the lamp will no longer flash during the next run.
NOTE!
If the opener is stopped during a reference run either manually or due to overloading,
the reference run concerned is invalid. In this case carry out the reference runs
until all reference runs are valid.
After installation, ensure that the opener stops the opening
movement if the door is weighted with a 20 kg load
that is attached to the centre of the lower edge of the
door. This check must be carried out if the door has one or
more openings with a diameter of 50 cm in the door wing.
After every setting or alteration to the end points you must adjust the force
setting. To do so, you must carry out 3 reference runs in each direction. The
opener carries out power measurements during these runs and automatically
adjusts the force setting.
During the reference runs there is a danger of injury as
the opener runs without force setting.
As long as the opener runs without force setting, the lamp will flash. At this
stage it is not possible to operate the door with a hand transmitter.