•
Choose File Button
Triggers the file selection dialog. Once the configuration backup file is selected, it is uploaded to
the unit. The upload action can take some time - depends on the speed of your service connection
to the unit.
•
Factory settings
Load default configuration
button loads default values of all configuration parameters into the
web interface. All parameters whose current value differs from the default are marked as changed.
They are listed in the Changes to commit dialog. They do not affect the running unit until eventually
send to the unit by the Send configuration button.
Note
This action can be used (for example) to check which set of parameters differs from the
default value.
•
Restore configuration button
Enabled after the backup configuration is uploaded. Press the button to restore the unit configur-
ation. The configuration restore result is reported as an error message (in case of failure) or No-
tification centre success message:
Restore factory settings
Restores all configuration parameters to default setup (including monitoring settings)
Deletes user database (only default user "admin" with default password will remain). Logout from
station will apply.
Total purge
Restores all configuration parameters to default setup (including monitoring settings)
Deletes user database (only default user "admin" with default password will remain). Logout from
station will apply.
Deletes all diagnostic logs and statistics
Clears Radio Tx and antenna degradation detector calibration
Note
Basic data such as Code, Region, SW keys will always remain in the unit.
Warning
This action can take up to two minutes - do not power off the unit until finished.
155
© RACOM s.r.o. – RipEX2 Radio modem & Router
Settings
