Raco 1190642-0010, Translation Of The Original Instruction

Page: 37 / 49

Revision: 05
5.2-6/11
154-625-2
5.2.7 Setting with the Windows
®
software (RACO Setup Tool)
Attention:
The EPS02 is factory set when delivered enclosed at an electric actuator (
unless otherwise specified
in the order, the final positions are usually set on both sides for maximum stroke length minus a stroke
reserve
), including the system-dependent rotation and the transmission ratio .
Caution when changing parameters, particularly the system-dependent parameters in order to avoid
malfunction and damage!
Before changing the original parameter date, save the data file and store it at a save place for using
this file in an emergency case to get the original state again. In a further file save the data set with the
changes which were made at site.
Procedure for saving data sets:
- Over the button "Read Parameter Block" read the parameters into the RACO Setup Tool.
- Select in the menu bar under "Values", "Save to File".
- Assign a file name and save the file.
To restore a saved data set, proceed as follows:
- Select in the menu bar under "Values" "Read from file".
- Select the desired parameter data set and open it.
- Over the button "Send Parameter Block", the parameters will be written to the EPS02.
To configure all functionality, a Windows
®
software (RACO Setup Tool) is provided, which allows all
settings conveniently. To change the parameters, after a successful connection to the PC, the param-
eters are first read from the EPS02 via the button "Read parameter block" in the RACO Setup Tool.
Modified parameters are restored via the "Send parameter block" in the EPS02.