© 2011 Racktivity Inc.
14/25
2100 Seaport Blvd., Suite 400, Redwood City 94063, USA – www.racktivity.com
v 2013.11.18
The following settings are only available when the DHCP checkbox is unchecked:
Ethernet
(Warning: when changing these values connection to the Web Portal might be lost)
•
IP
-
Address
: The IP-address used for TCP/IP configuration
•
Subnetmask
: The subnet mask used for TCP/IP configuration
•
Std
Gateway
: The standard gateway used for TCP/IP configuration
•
DNS
-
server
: The DNS-server used for TCP/IP configuration
•
DHCP
: When checked the PDU will automatically be assigned an IP-address (if a DHCP
server is present on the network)
SNMP
•
Community
read
: Sets the community read string, default: "public". When using SNMP
software on a pc to collect SNMP data (GET command) this string is used as verification
•
Community
write
: Sets the community write string, default: "private". When using SNMP
software on a pc to change SNMP data (SET command) this string is used as verification
•
Write
protection
: When checked this setting will prevent changes being made through
SNMP (SET command), even when using the correct Community write string. It can be
used as an additional protection
•
Trap
receiver
port
: Sets the port for the SNMP Trap function, default: "162"
•
Trap
receiver
IP
: Sets the IP address where the SNMP Trap is sent, this is normally the IP
of a monitoring computer on the same network
OLED
•
Min. before Off:
Sets the OLED standby delay when no buttons are pressed (in minutes)
•
Brightness [2-10]:
Sets the OLED's brightness
•
Login
: Sets a new login and password. The default values are:
Login
: admin
Password
: 1234
Logging
•
Sets the logging values for the Logging tab
o
Short
term
: From 1 - 255 seconds
o
Medium
term
: From 1 - 255 minutes
o
Long
term
: From 2 - 255 medium term intervals (specified in the above setting)
After editing the settings on the Settings tab, press the Save Data button. A pop-up will appear
after the changes have been successfully saved.
Time Settings (UTC)
The following settings are only available when NTP is unchecked
•
Time
(
HM
): Sets the time (in hours:minutes)
•
Date
(
DMY
): Sets the date (in days/months/years)
•
Local
NTP
-
server
: NTP server IP when Use Default NTP Server is not checked
•
Use
Default
NTP
server
: When checked the PDU will connect to pool.ntp.org for the time
settings
•
NTP
: When checked the PDU will try to get time settings from an NTP server
Summary of Contents for PM0816-01
Page 1: ...User manual PM0816 01 ...