![background image](http://html1.mh-extra.com/html/racal-instruments/an-trc-199/an-trc-199_additional-installation-operation-and-maintenance-instructions_3129814032.webp)
TO 31R2-2TRC199-1
CHAPTER 3.0 PREPARATION FOR USE AND RESHIPMENT
3-1
INTRODUCTION.
This chapter is divided into two sections. Section I. Preparation For Use provides post-installation operational checks
that must be performed prior to operating the tactical repeater. Section II. Preparation For Reshipment contains
procedures for reshipment of the unit.
Section I. PREPARATION FOR USE
3-2
INSPECTION.
If the tactical repeater has not been inspected as part of the installation process, or if the equipment has not been used
recently, check to ensure that all cable connections are tight and no damage is visible on the exterior of the tactical
repeater.
3-3
POST-INSTALLATION CHECKOUT.
3-3.1
Preliminary.
Before performing the post-installation checkout procedures of paragraph 3-3.3, perform the following preliminary
procedure.
a.
Ensure that both receiver-transmitters (SS-4100807-512) have been programmed with the correct
frequencies and squelch. (TO 31R2-2PRC139-1 describes procedures for programming all
programmable parameters. All necessary programming must be performed prior to inserting the
receiver-transmitters in the tactical repeater.)
b.
Ensure that the mode switches on both receiver-transmitters are set to CLR and the SCAN switch is
turned off.
NOTE
Other programmable parameters may be set to any value.
NOTE
Be sure to align the receiver-transmitters so that the orientation of the control knobs and
connectors corresponds to the markings on the sleeve door. The receiver-transmitters cannot be
inserted in the tactical repeater with the battery attached.
c.
Insert the receiver-transmitter (SS-4100807-512) for the transmit frequency into the right sleeve of the
tactical repeater, with the side connectors facing up (refer to Figure 1-1). Turn the cam above the
receiver-transmitter clockwise until it locks (1/4 turn).
d.
Insert the receiver-transmitter (SS-4100807-512) for the receive frequency into the left sleeve of the
tactical repeater, with the side connector facing up (refer to Figure 1-1). Turn the cam above the
receiver-transmitter clockwise until it locks (1/4 turn).
e.
Place the DISPLAY switch in the ON position to verify proper installation. Place the power supply
AC/DC POWER switch in either AC or DC position, depending on the source of power. If DC is
selected, the DC SEL switch must be set for either internal (INT) or external (EXT) DC power source.
Confirm that the POWER light emitting diode (LED) is illuminated green and the FAULT LED is not
illuminated.
Summary of Contents for AN/TRC-199
