1257 User Manual
Computer Interfaces 4-24
EADS North America Defense
Test and Services, Inc.
©
2001
NOTE:
Menu preferences are not normally retained after the power is
removed from the instrument. To make (a) menu preference(s)
permanent, make the desired change(s) to settings first and
then proceed to the section Storing the Menu Preferences to
make the changes permanent. Following this procedure will
put the settings into non-volatile memory and allow them to
be restored during instrument power-up.
Using Microsoft
HyperTerminal
One of the easiest ways to manually control the 1257 through the
RS-232 interface is to use HyperTerminal. HyperTerminal is a
terminal emulation program that is included with Windows 95 and
98.
Before using HyperTerminal, or any other terminal emulation
program, set up the 1257 RS-232 parameters as follows (refer to
the above sections for details about accessing these settings via
the front-panel controls):
Baud
rate: 9600
Data
Bits: 8
Parity:
None
Stop
Bits: 1
Flow
Control:
Disabled
EOL
Mode:
CR/LF
To run HyperTerminal, click on Start, click on Run, then type:
hypertrm
(use the exact spelling above). Then press Enter.
The HyperTerminal program then starts, and displays the
Connection Description dialog box as shown in
Figure 4-5
.
Summary of Contents for 1257
Page 6: ......
