1257 User Manual
Using the Front Panel Controls 3-16
EADS North America Defense
Test and Services, Inc.
©
2001
Status: GPIB
3.
Select line 3 by pressing the third key. Rotate the knob until
line 3 reads as shown below:
-----SETTINGS-----
Type: Remote
> Option: Lockout <
Status: Disabled
4. If line 4 already shows the desired status, then no further
action is necessary. Otherwise, select line 4. Then rotate the
knob until the desired state (“Enabled” or “Disabled”) shows
on line 4. This example uses “Enabled”:
-----SETTINGS-----
Type: Remote
Option: Lockout
<Update?: Enabled
Then press the fourth key (bottom) to update the status.
Pressing any other key cancels the change.
NOTE:
Menu preferences are not normally retained after the power is
removed from the instrument. To make (a) menu preference(s)
permanent, make the desired change(s) to settings first and
then proceed to the section Storing the Menu Preferences to
make the changes permanent. Following this procedure will
put the settings into non-volatile memory and allow them to
be restored during instrument power-up.
Setting RS-232 Parameters
For detailed instructions on setting RS-232 parameters, such as
baud rate and parity, refer to
Chapter 4, COMPUTER
INTERFACES
.
Setting GPIB Address and SRQ Settings
For detailed instructions on setting the GPIB address and SRQ
settings, refer to
Chapter 4, COMPUTER INTERFACES
.
Setting Ethernet IP, Netmask, and Gateway Settings
For detailed instructions on setting Ethernet options, refer to
Chapter 4, COMPUTER INTERFACES
.
Summary of Contents for 1257
Page 6: ......
