![background image](http://html1.mh-extra.com/html/r-v-r-elettronica/sdc2000/sdc2000_user-manual_3105940028.webp)
SDC2000
24 / 40
User Manual
Rev. 1.0 - 12/04/05
[I.T.U.]
If the encoder is pushed when in this submenu, field [BACK] begins
to blink and you will be able to move the cursor from field to field by
turning the knob in the desired direction.
Push the encoder again when a field is selected to confirm that you
wish to edit the current selection.
[BACK]
Push the encoder when this item is blinking to cancel
selection mode and go back to scrolling through display
screens by turning the knob.
[IS OFF]
Push the encoder when this item is blanking to change
the state of the I.T.U. feature.
NOTE: Enabling the I.T.U. results in forced clipper enable
and A.G.C. disable.
[AGC S.] Push the encoder when this item is blinking to change
operation and release time. You may toggle between
OFF, SLOW (slow operation time), MIDDLE (normal
operation time), FAST (fast operation time).
NOTE: Attenuation must always be lower than gain,
otherwise malfunctions may occur.
NOTE: Enabling the clipper ensures smoother A.G.C.
operation; otherwise, modulation is bound to exceed the
75kHz deviation limit repeatedly.
NOTE: May only be set when the I.T.U. feature is
disabled.
[IS ON]
Push the encoder when this item is blinking to change
the state of the CLIPPER feature.
NOTE: May only be set when the I.T.U. feature is
disabled.
[clipp]
If the encoder is pushed when in this submenu, field [BACK] begins
to blink and you will be able to move the cursor from field to field by
turning the knob in the desired direction.