SDC2000
25 / 40
User Manual
Rev. 1.0 - 12/04/05
Push the encoder again when a field is selected to confirm that you
wish to edit the current selection.
[BACK]
Push the encoder when this item is blinking to cancel
selection mode and go back to scrolling through display
screens by turning the knob.
[IS ON]
Push the encoder when this item is blinking to change
the state of the CLIPPER feature.
NOTE: May only be set when the I.T.U. feature is
disabled.
level:[+00,00]
Push the encoder when this item is blinking to set the
level of the clipper feature. The allowed setting range is
+/-12 dBu in 0.1 dB increments.
NOTE: The clipper has been designed so as to avoid
compromising stereophony up to signals 6 dB greater
than the clipper.
MPX-IN:[+00,00]
Push the encoder when this item is blinking to set clipper
level for thedigital MPX input. The allowed setting range
is +/-12dBu in 0.1 dB increments.
6.5.1.3
[rds]
RDS Section Submenus
Pushing the encoder when this item is blinking gives access to a set of submenus
where you can edit certain parameters of the RDS section.
If the encoder is pushed when in this submenu, field [BACK] begins to blink and you
will be able to move the cursor from field to field by turning the knob in the desired
direction.
Push the encoder again when a field is selected to confirm that you wish to edit the
current selection. Please read the next paragraph for menu edit instructions.
[BACK]
Push the encoder when this item is blinking to cancel selection
mode and go back to scrolling through display screens by turning
the knob.
