R-Co Kingsman FDV451LP, Installation Instructions Manual

Page: 51 / 73

- Lighting Instructions - Intermittent Pilot Ignition System (IPI)
A. This appliance is equipped with an ignition device which
automatically lights the pilot. Do not try to light the pilot
by hand.
B. BEFORE OPERATING smell around the appliance
area for gas. Be sure to smell next to the floor because
some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
 Do not try to light any appliance.

Do not touch any electric switch; do not use any phone
in your building.
 Immediately call your gas supplier from a neighbor’s
phone. Follow the gas supplier’s instructions.
 If you cannot reach your gas supplier, call the fire
department.
C. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician
to inspect the appliance and replace any part of the
control system and any gas control which has been
under water.
D. If the gas valve requires repair, call a qualified service
technician. Force or attempted repair may result in a
fire or explosion.
1. Stop! Read the safety information above on this label.
2. Remove batteries from receiver, and/or Battery Backup
Pack.
3. Turn off all electric power to the appliance.
4. This appliance is equipped with an ignition device which
automatically lights the pilot. Do not try to light the pilot
by hand.
5. Open the glass
door.
6. Turn manual shutoff valve clockwise to off
(Located behind the access panel).
7. Wait five (5) minutes to clear out any gas. Then smell
for gas, including near the floor. If you smell gas,
STOP! Follow “B” in the safety information above this
label. If you do not smell gas, go to next step.
8. Turn manual shutoff valve counter-clockwise to
on.
9. Close the glass door.
10. Turn on all electric power to the fireplace and re-install
batteries into the Transmitter/Receiver, and/or Battery
Backup Pack.
11. Turn “On” Switch that operates the Main Burner. If
using a Remote Control refer to Remote Control
Operation Manual for activation.
12. If the appliance will not operate, follow the instructions
“To Turn Off Gas To Appliance” and call your service
technician or gas supplier.
1. Turn off all electric power to the fireplace if service is to
be performed, including removing batteries from
Remote Transmitter/Receiver and/or Battery Backup
Pack.
2. Remove control access panel.
3. Turn manual shutoff valve clockwise to off
(Located behind the access panel).
If alternate shut-off valve was installed it can be shut
off instead of going through the fireplace to access the
fireplace shutoff valve.
4. Replace control access panel.
WARNING: If you do not follow these instructions exactly, a fire or explosion may result
causing property damage, personal injury or loss of life.
Always light the pilot whether for the first time or if the gas supply has run out with the glass
door opened or removed.
FOR YOUR SAFETY READ BEFORE LIGHTING
OPERATING INSTRUCTIONS
TO TURN OFF GAS TO APPLIANCE
BEFORE LIGHTING:
51