Controlling multiple lasers
QuickShow allows you to control up to nine* separate FB3 laser controllers connected to the computer
via USB (normally using one or more powered USB hubs). Simply connect multiple FB3s to the
computer, and QuickShow will automatically recognize them, and place an icon in the status bar portion
of the program.
(* Note that the number of FB3 that QuickShow can control depends strongly on the horsepower of your
computer. The more FB3s you connect to a single computer, the faster your computer will need to be
since QuickShow computes the output for all laser systems using the PC processor.)
First steps
Once you have connected more than one FB3 to your computer, you should do the following:
I.
Adjust the Projector Settings for each FB3 in order to optimize the settings for each projector.
II.
Adjust the Geometric Correction, and perhaps other parameters using the Projection Zones
dialog box.
Once you have setup the projector settings and geometric correction for each projector, you can now
direct QuickShow cues to the individual lasers using one of two methods:
I.
Specify which laser to use within the cue properties of each cue.
II.
Use "zone hot keys" to indicate where to send cues.
95
Summary of Contents for FB3-QS
