Quickie Q2 Lite, Construction Manual

Page: 182 / 299

lumber bracing. When everything is jigged properly, 5-MIN blobs are used
to attach the pant to the canard and a piece of lumber is attached
between the LG4 insert and the canard so that the assembly will not
move. Begin by rigging the wheel pant in the approximate position. The
wheel pant slips into place against the canard shear web and canard
bottom skin. Since the canard surface is angling upward as fixed to the
jigging table, and since the vertical faces of the wheel pant should be
vertical, some beveling of the pant where it fits against the canard is
necessary. The bevel is approximately 1 to 10. Note that the LGI core is
sized to fit at BL93, so don't modify the inboard edge very much. Once
the assembly is trimmed, bracing is used to keep it firmly fixed. Sight
thru the axle holes, keeping the two holes in the wheel pant concentric
(like sighting thru the sights on a gun). Move the wheel pant until the
line of sight approximately intersects the other canard tip where the
axle holes on the wheel pant will be located. Bondo the lumber in place.
..... Next, repeat the operation with the other wheel pant except that
now you can actually sight on the opposing wheel pant axle holes.
CONTINUED ON NEXT PAGE
PAGE 11-1